Oil-bearing hardness factor
Phosphor bronze brass flange bushinghardness due to overheating while reducing the concern, therefore, must not exceed 100 degrees. In this case, the use of steel bearings must be suspended or placed on top of a wire link, the support
Steel+Nylon BTU bearing, not placed in the bottom. Bearing reached the desired temperature (100 degrees), it should be immediately removed from the tank, quickly set into the shaft, bearings will shrink as the temperature dropped, and sometimes between the
Oil sintered bushing shoulder and the bearing end face gap will, therefore, need to use the tool, to the bearing axis pressed.
