The balanced operation method of low price grinding disc

148 views 0 replies
Reply to Topic
juniperqq

Age: 2023
Total Posts: 19
Points: 10

Location:
https://www.chinahengzesteel.com/ppgi-corrugated-roofing-sheet/,
The low price grinding disc can be said to be very common in our lives, and the application is quite extensive. Some manufacturers print arrows on the light side of the grinding disc. The number at the arrow indicates "grams". These plus The quality of the grams is to balance the disc for easy operation. Although the number of grams is marked, the balance mass cannot be added to the outside of the low price grinding disc. If the balance is to be added to the flange, the disc is the High-speed rotation, so a little imbalance will cause the grinding machine to vibrate and cause danger. The following grinding disc cutting chip manufacturers describe the balancing operation of the grinding disc.
 
When the low price grinding disc is balanced, the balance frame should be leveled with the level. If it is not leveled, the balance is meaningless.
 
When the low price grinding disc is mounted on the flange, the hole of the flange should be cleaned, and then the shaft for balancing should be installed and tightened with a nut. This is the same as the method of installing the grinding disc on the spindle of the conventional grinding disc, and then put it into balance. After the rack is placed, the heavy part of the grinding disc rotates downwards, and the lighter part turns to the top and stops. After that, the balance block mounted on the flange is adjusted to Light side, and fixed with screws. If you only balance one turn, it is impossible, it is impossible, not so simple. Of course, there is almost no balance block corresponding to the imbalance, the imbalance on the circumference of the low price grinding disc and its Related to the distance to the center, when the flange is adjusted, 2 - 3 balance blocks are needed, and the balance can be achieved by changing the different positions. The correct balance method is to adjust the horizontal direction of the arrow to make it slowly stop. Balance In addition to the two balance bars, there are two thin, freely rotatable discs placed on both sides of the balanced disc axle. In addition, there is a balance table. You can also use the balance principle to check the vibration of the machine, you can also use the stroboscopic vibrometer to install it on the machine When measuring.
 
Then the above content is the balance operation method of the low price grinding disc manufacturer's description of the grinding disc. Our Henan Aurora Abrasive Tool Co., Ltd. produces the grinding disc cutting piece with strict quality requirements and sufficient strength. The rotating strength of the normal cutting piece reaches 1.5. Times is a Chinese grinding disc manufacturer and wholesaler worthy of your trust. For details, please visit the website.
Posted 28 Nov 2018

Reply to Topic