1. Antenna adjustment
The gain of the wireless communication system is equal to the sum of the transmit power of the wireless module and the gain of the antenna, so the gain of the antenna has a great relationship with the transmission distance of the wireless module. In the case that the module and the antenna are matched, the higher the gain of the antenna, the longer the transmission distance of the wireless module.
Generally, the gain of a small suction cup is only about 2.0dBi, and some good outdoor large antennas can reach a gain of about 5dBi. If the effect of using a small gain antenna with a wireless module for data transmission is not satisfactory, you can replace the antenna with a higher gain, and the wireless module will transmit farther.
At the same time, it is also necessary to pay attention to the directivity and installation method of the antenna. Set the antenna as high as possible. Adjust the antenna connected to the wireless module to be placed in the same horizontal plane and parallel state, so that the sensing surface for wireless signal transmission and reception is the largest. The intensity of the electromagnetic wave signal is the largest, so that the wireless transmission distance is longer.
2.Transmission path
The wireless module for wireless data communication is realized through the linear transmission of wireless electromagnetic waves in the air, so the occlusion of obstacles has a great impact on the wireless transmission, especially the obstacles of metal objects, which not only block the wireless transmission signal, it can also absorb And reflect electromagnetic wave signals, reducing radiation efficiency. Therefore, the biggest obstacles for wireless transmission are actually metal, houses, woods, grass, sea level and other objects that can play a blocking role.
3.Transmitter and receiver adjustment
Arrows RC airplane
Atten soldering gun
FMS RC jet
Kerui GSM alarm
Freewing RC jet
First, you need to consider the application scenario and determine the distance to be transmitted. If you need to transmit over a longer distance, consider whether the wireless module has a power amplifier (PA) and a low noise amplifier (LNA), otherwise it will not be able to achieve long-distance wireless transmission.
4.Working frequency adjustment
The wireless channel is relatively crowded, especially the ISM frequency band. During the actual installation of the communication equipment, the local electromagnetic environment can be spectrum surveyed, and relatively "clean" frequency points can be selected to avoid unnecessary interference. At the same time, strict compliance is required. Local laws and regulations carry out frequency planning.
The communication distance is a comprehensive index of the wireless module, which is affected by many conditions, factors and parameters. In general, the wireless transceiver module should achieve the ideal wireless transmission effect:
1. Make the preliminary planning and selection, mainly for the power supply and the wireless module to be used
2. Elevate the antenna placement point or offset the placement point of the antenna at both ends of the transceiver to reduce the obstruction of obstacles, reduce the attenuation of electromagnetic wave signals, and reduce the blind area of wireless signals
4. Use an antenna with high gain and matching wireless module to match the user's application scenario
