Now
115 golden star cutting disc are used more and more widely, and only when you have more relevant common sense
can you use it better. I will give you a brief introduction today.
First, the inner diameter is damaged.The main cause of this phenomenon is improper assembly. The cutting piece is
used as a grinding disc and the flange is partially lost.
Second, if the tangential line is notstraight or damaged, this is mainly due to the improper diameter of the
assembly flange, the assembly flange is not working well, the machine is not
working properly; or the workpiece is improperly clamped, the cutting pressure
is too large, the slice is too Caused by thin.
Third, the main cause of discolorationof the cut surface is that the slice is too hard, and the cross-sectional area
of the object to be cut is larger than the slice diameter. There is also the
result of long cutting time and low motor power.
Fourth, if it is worn out, this ismainly caused by the machine speed being too large and the peripheral speed is
too fast. In addition to this reason, it is necessary to note that if the cut
surface is white, the slice is too soft. If the cut surface is discolored, the
degree of consolidation is too hard.
Fifth, the rim tear and this phenomenon aremainly caused by the use of the cutting piece as a grinding piece, that is,
caused by improper use. Or the workpiece is caught by the spring due to
improper operation of the machine.
