Most customers put the screw press directly into operation when they bought it back, and did not pay attention to the daily maintenance of the oil press when it was working. The oil press is often turned off directly after use. This kind of wrong operation makes the service life of the screw press drastically reduced. Customers often ask their oil press manufacturers, is your machine bad? In fact, it is not the case. Customers only need to pay attention when using the screw press. For the daily maintenance of the oil press, the lifespan of the machine will increase, which will produce greater benefits
mango pulp maker machine, isn’t it? How to maintain it? The machine will briefly tell you the daily maintenance of the screw press:
Maintenance manual for screw press:
1. The lubrication should be checked after every 50 hours of work. The oil cup above the reduction box must not be short of oil. The inner bearing of the screw shaft adjustment screw should be filled with butter once per shift from the adjustment screw hole. Dry grinding is strictly prohibited.
2. The lubricating parts should prevent the intrusion of dust and other impurities
mango pulp maker machine. The oil quality of the gearbox should be checked once a year. All the oil should be changed if it is found to have changed.
3. When the squeezing volume decreases and the cake or oil output is abnormal, the screw shaft should be pulled out, and the wear of the screw, squeezer, and cake ring should be checked, and the worn parts should be replaced in time.
4. After the end of each shift, the residual cake in the machine should be cleared immediately, and the dust and grease on the surface of the machine should be wiped off.
5. When the oil press is stored for a long time, you should pay attention to the comprehensive maintenance at one time
electric sugarcane juicer machine, and remove and wash the snails, squeezed strips, and cake rings to re-paint.
Sixth, the screw oil press should regularly use butter or machine oil to smooth all parts. The ordinary copper sleeve and the adjusting screw sleeve are added with oil once after 4-6 hours of operation. After the rolling bearing is used for 3 to 4 months, stop cleaning and refill with butter.
7. After the oil press equipment has been working for 3 to 4 months, stop an overhaul. In the screw press, the maintenance items include: adjusting the concentric condition of the screw shaft and the press chamber; checking the wear condition of the vulnerable parts such as the screw press, the press bar and the cake ring. The wear of the snails usually occurs on the last three buckles of the thread. When the consumption efficiency is affected by the wear, the new ones must be replaced. After the press rod is worn out, it becomes an arc shape, which will reduce the press chamber pressure. If the amount of wear reaches 2 mm, the surface can be replaced and used, and it must be replaced with a new one after both surfaces are worn.
