1. Activated carbon should be prevented from being mixed with hard substances during transportation. It should not be violently shaken, rubbed, stepped on or smashed. Throwing is strictly prohibited. It should be handled with care and unloaded to reduce the broken carbon particles and affect the use. 2. Activated carbon is a porous adsorbent, so during transportation, storage and use, it should be stored in a cool and dry place to prevent the outer and inner packaging bags from breaking, and prevent moisture and adsorption of other substances in the air, which will affect the application. imagitarium activated carbon pellets It is strictly forbidden to mix it with toxic and harmful gases or volatile substances, and keep it away from pollution sources. Moreover, it is necessary to prevent water immersion, because after water immersion, water fills the pores of activated carbon, reducing the direct contact of activated carbon with gas and seriously affecting the use of activated carbon. 3. In the process of use, stop tar-like viscous substances from entering the activated carbon bed, so as not to block the pores of the activated carbon, so that the gas cannot open the surface to touch with the activated carbon, and make it lose the adsorption effect. If the gas contains such substances, it should be eliminated before the gas enters the activated carbon bed (the effect of decoking equipment is better) to achieve a good application effect. 4. When storing or transporting activated carbon, avoid direct contact with the fire source to prevent fire. When activated carbon, prevent oxygen from entering, and then use steam to cool down to below 800?, otherwise the temperature will be too high and activated carbon will spontaneously ignite when exposed to oxygen. 5. When filling, sift out the broken particles and dust caused by transfer. Then spread the layers evenly, and do not pour directly from the feed hole, so as to avoid uneven filling of large and fine particles, and eventually form a gas flow, which will affect the application. After the filling is completed, the air should be blown before driving to blow out the dust on the surface of the activated carbon to prevent the dust from being carried into the rear section after driving and affecting normal production.https://www.coconutactivatedcarbon.com 6. The power of activated carbon to treat water quality is related to its treatment dosage. Generally, the effect of treating water quality with more dosage is relatively good. Clean and remove dust before use, otherwise these black dust may temporarily affect the cleanliness of water quality. However, it is recommended not to flush with fresh tap water directly, because the porous activated carbon once adsorbs a large amount of chlorine and bleach in the tap water, it will damage the water quality when it is placed in the filter for use. 7. Activated carbon should be replaced regularly to prevent the effect of "full adsorption" of activated carbon and loss of effectiveness. And when to replace it, don’t wait for it to fail and then replace it later, generally 1-2 times a year.
