A 360 Lace Front Wigs is attached with tape or glue. Any of the two could tightly stick your lace wig given that it is positioned right; whatever adhesive you like to employ is up to you. The critical part is to spread over the adhesive appropriately so you will not go through difficulties in disconnecting the wig later on. To shield your real hair, use a wig cap and make sure that all the sections where your true hair develops are wrapped. The color of the wig cap needs to equal the color of your skin for a more undetectable appearance.
The lace base of the wig is attached to your head along the hairline, so you need to make sure that this part is dirt-free. Put on a bit of alcohol in cotton and swab your hairline until it is free from blemishes. Allow the alcohol to dry for 30 seconds before using the adhesive.
Attachment Options
1. Glue Application
The special glue for 360 Lace Frontal Wig is usually available with a brush but if there is none, you could utilize other tiny brushes. You need to apply the glue delicately and in an even way; it needs to be dabbed one inch below your hairline. After you spread the glue, slowly place the lace base of the wig on the glued area. Allow the glue to dry for 15 minutes and the wig would be safely attached. You can even use a blower to rush the drying time.
2. Tape Application
This treatment is just like using glue. Wig tapes typically come in double-sided rolls. Strip off the first side of the tape and stick it underneath the hairline. When the tapes are in position, unwrap the other side and carefully arrange the lace base on the adhesives. You must ensure that the lace front wholly meets with the sides of the tape strips. Hold down the lace base for 30 seconds up to 1 minute. It's the same application for the nape but you need to use a mirror to ensure that the process is done correctly.
I hope you have found this guide useful. If you need any more help just let us know either by visit mslynnhair.com
